Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • User (Old forums)
    Member
    Post count: 23064
    #42750 |

    while I upload, I called ‘put_Abort(VARIANT_TRUE)’ and I got an error message if I called ‘Disconnect()’.

    The error message is ‘FTP_E_BUSY’.

    I got an the error message every time, when the situation is same as above.

    What can I do??

    sorry about my bad english..

    Imported from legacy forums. Posted by oh (had 4677 views)

    User (Old forums)
    Member
    Post count: 23064

    It is possible that you call Disconnect() before the Abort call has finished. Are you using BackgroundProcessing?

    Imported from legacy forums. Posted by André (had 342 views)

    User (Old forums)
    Member
    Post count: 23064

    no.. it’s not a BackgroundProcessing..

    I tryed to Abort() before Disconnect() while a file downloading.. but it had not an

    error..

    It happened only while UPLOADING..

    the error message is shown when the order was below..

    1. ‘UPLOADING’ situation.

    2. call ‘Abort()’

    3. call ‘Disconnect()’

    4. the error message happen.

    What do I do? is that a XCEED_FTP’s own falt?

    Imported from legacy forums. Posted by oh (had 482 views)

    User (Old forums)
    Member
    Post count: 23064

    Can you set the CommandLogFilename, and send the resulting file to <a href=”mailto:support@xceedsoft.com”>support</a>, with as much details as possible on what you are doing, which FTP server you are connected to, if there is a firewall/proxy involved, the code you are using to do the job?

    Imported from legacy forums. Posted by André (had 5161 views)

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.